Locate the line (line #1188 in my version) AVRDUDESS is a GUI for AVRDUDE, a tool for programming Atmel microcontrollers. The strange thing is that it worked just fine when I did it the first time but I forgot to enable the TMC-drivers so I went ahead and uncommented that in the configuration but now it wont even flash. Extract the .rar file in a folder.. I have personally used usbasp and avrdude on Windows 7 and Windows 10 platforms. Make sure you get AVRdudess 2.4 GUI and make sure it uses Avrdude 6.3. Then give -i 1000 or similar delay value to avrdude … Flashing Ender3 December 2, 2018 Ender 3 Raspberry Pi. {runtime.tools.avrdude.path} is defined by the boardsmanager based n the json file and the location where the boardsmanager extracted the download. Copy the Marlin folder to a better location and edit the Configuration.h file.. Change the language for display. Also, we have included the known working version of avrdudess version 2.4 which has avrdude 6.3 underneath. FYI, Avrdudess 2.4 is the GUI that runs Avrdude 6.3 under the hood. Click on Download button and save the .rar file. But avoid …. To get a list of parts supported by avrdude, type in avrdude -c avrisp (it doesnt matter if you're not useing an avrisp programmer) without a part number into the command line. My problems were more Windows related than Arduino related, and my solution wouldn't work for most folks, but I add it anyway as another viewpoint. I have installed Arduino IDE in …
Unfortunately if you click on either link you end up with the same file: "Ender-3 Pro1.1.6.2 resume printing.hex" Hopefully they will get it posted soon.

Thanks for contributing an answer to Stack Overflow!

It runs off of our supplied USB drive in the Uptanium USBasp Bootloader and Snapshot kit.
Sumber dari : aminoapps.com. Click on Download button and save the .rar file.

Locate the Marlin folder inside the folders created by the Unrar tool.. Make sure you get AVRdudess 2.4 GUI and make sure it uses Avrdude 6.3. Please be sure to answer the question.Provide details and share your research! Meantime, if anyone has the 1.1.8 silent board for an ender 3 pro and knows how to use avrdude or whatever other means to dump a copy of the firmware, I would appreciate it. I installed avrdude and when I click test it says path doesn't exist: [octoprint_pathdoesntexist] But it does exist there: [avrdude] …

Locate the line (line #1188 in my version) The additional component are not firmware. If you don’t have it already you can download if from arduino.cc. Locate the Marlin folder inside the folders created by the Unrar tool.. Ender 3 picture in the download page. It is assumed you already have OctoPrint running on a Raspberry Pi.